web analytics

Purchase 20% Discount Real 200-120 Exam Dumps from Passleader With 100% Pass Ensure (21-40)

QUESTION 21
Which two protocols are used by bridges and/or switches to prevent loops in a layer 2 network? (Choose two.)

A.    802.1d
B.    VTP
C.    802.1q
D.    STP
E.    SAP

Answer: AD

QUESTION 22
Which switch would STP choose to become the root bridge in the selection process?

A.    32768: 11-22-33-44-55-66
B.    32768: 22-33-44-55-66-77
C.    32769: 11-22-33-44-55-65
D.    32769: 22-33-44-55-66-78

Answer: A

QUESTION 23
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?

A.    More collision domains will be created.
B.    IP address utilization will be more efficient.
C.    More bandwidth will be required than was needed previously.
D.    An additional broadcast domain will be created.

Answer: D

QUESTION 24
What are three benefits of implementing VLANs? (Choose three.)

A.    A higher level of network security can be reached by separating sensitive data traffic from other network traffic.
B.    A more efficient use of bandwidth can be achieved allowing many physical groups to use the same network infrastructure.
C.    A more efficient use of bandwidth can be achieved allowing many logical networks to use the same network infrastructure.
D.    Broadcast storms can be mitigated by increasing the number of broadcast domains, thus reducing their size.
E.    Broadcast storms can be mitigated by decreasing the number of broadcast domains, thus increasing their size.
F.    VLANs make it easier for IT staff to configure new logical groups, because the VLANs all belong to the same broadcast domain.
G.    Port-based VLANs increase switch-port use efficiency, thanks to 802.1Q trunks.

Answer: ACD

QUESTION 25
Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over Fast Ethernet?

A.    802.3ad
B.    802.1w
C.    802.1D
D.    802.1Q

Answer: D

QUESTION 26
Which of the following are benefits of VLANs? (Choose three.)

A.    They increase the size of collision domains.
B.    They allow logical grouping of users by function.
C.    They can enhance network security.
D.    They increase the size of broadcast domains while decreasing the number of collision domains.
E.    They increase the number of broadcast domains while decreasing the size of the broadcast domains.
F.    They simplify switch administration.

Answer: BCE

QUESTION 27
In an Ethernet network, under what two scenarios can devices transmit? (Choose two.)

A.    when they receive a special token
B.    when there is a carrier
C.    when they detect no other devices are sending
D.    when the medium is idle
E.    when the server grants access

Answer: CD

QUESTION 28
Which two states are the port states when RSTP has converged? (Choose two.)

A.    discarding
B.    listening
C.    learning
D.    forwarding
E.    disabled

Answer: AD

QUESTION 29
Which two commands can be used to verify a trunk link configuration status on a given Cisco switch interface? (Choose two.)

A.    show interface trunk
B.    show interface interface
C.    show ip interface brief
D.    show interface vlan
E.    show interface switchport

Answer: AE

QUESTION 30
Which command enables RSTP on a switch?

A.    spanning-tree uplinkfast
B.    spanning-tree mode rapid-pvst
C.    spanning-tree backbonefast
D.    spanning-tree mode mst

Answer: B


Purchase 20% Discount Real 200-120 Exam Dumps from Passleader With 100% Pass Ensure

http://www.passleader.com/200-120.html

QUESTION 31
What is the function of the command switchport trunk native vlan 999 on a Cisco Catalyst switch?

A.    It creates a VLAN 999 interface.
B.    It designates VLAN 999 for untagged traffic.
C.    It blocks VLAN 999 traffic from passing on the trunk.
D.    It designates VLAN 999 as the default for all unknown tagged traffic.

Answer: B

QUESTION 32
Why will a switch never learn a broadcast address?

A.    Broadcasts only use network layer addressing.
B.    A broadcast frame is never forwarded by a switch.
C.    A broadcast address will never be the source address of a frame.
D.    Broadcast addresses use an incorrect format for the switching table.
E.    Broadcast frames are never sent to switches.

Answer: C

QUESTION 33
Which two link protocols are used to carry multiple VLANs over a single link? (Choose two.)

A.    VTP
B.    802.1q
C.    IGP
D.    ISL
E.    802.3u

Answer: BD

QUESTION 34
Assuming the default switch configuration, which VLAN range can be added, modified, and removed on a Cisco switch?

A.    1 through 1001
B.    2 through 1001
C.    1 through 1002
D.    2 through 1005

Answer: B

QUESTION 35
Which statement about VLAN operation on Cisco Catalyst switches is true?

A.    When a packet is received from an 802.1Q trunk, the VLAN ID can be determined from the source MAC address and the MAC address table.
B.    Unknown unicast frames are retransmitted only to the ports that belong to the same VLAN.
C.    Broadcast and multicast frames are retransmitted to ports that are configured on different VLAN.
D.    Ports between switches should be configured in access mode so that VLANs can span across the ports.

Answer: B

QUESTION 36
Which three statements about RSTP are true? (Choose three.)

A.    RSTP significantly reduces topology reconverging time after a link failure.
B.    RSTP expands the STP port roles by adding the alternate and backup roles.
C.    RSTP port states are blocking, discarding, learning, or forwarding.
D.    RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.
E.    RSTP also uses the STP proposal-agreement sequence.
F.    RSTP uses the same timer-based process as STP on point-to-point links.

Answer: ABD

QUESTION 37
At which layer of the OSI model is RSTP used to prevent loops?

A.    physical
B.    data link
C.    network
D.    transport

Answer: B

QUESTION 38
What does a Layer 2 switch use to decide where to forward a received frame?

A.    source MAC address
B.    source IP address
C.    source switch port
D.    destination IP address
E.    destination port address
F.    destination MAC address

Answer: F

QUESTION 39
Which two benefits are provided by creating VLANs? (Choose two.)

A.    added security
B.    dedicated bandwidth
C.    provides segmentation
D.    allows switches to route traffic between subinterfaces
E.    contains collisions

Answer: AC

QUESTION 40
Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?

A.    pingaddress
B.    tracertaddress
C.    tracerouteaddress
D.    arpaddress

Answer: A


Purchase 20% Discount Real 200-120 Exam Dumps from Passleader With 100% Pass Ensure

http://www.passleader.com/200-120.html